Woodworking Stuff

Sketchup model available for download HERE.  

I see some MDF, I want it painted black. Note drawers are fitted/ installed.  Have to paint the fronts, install hinges and pulls, and the...

Don't have a router table yet, so the drawers are getting biscuits.  Here're the parts with the insides pre-finished.  Pre-fini...

Four of the five cabs glued up and staged. Note the drawer slides sitting in the bottom of cab 2 (from the left), and the stack of drawer ...

Room to work:  4 or 5 cabinets layed out for finish. The sink base dry fit.

Planning a move to a house with... a.... THREE.... car... detached... garage.  Power, heat, lights, water, loft. Woodworking '10-'...

Here's one of the first "in our house" projects to come out of the shop: a "built-in" desk set-up that Wife commiss...

I've vowed to never post worthless musings. I break that vow today for a few notes for my own memory. 1. Attended the Reading, PA woo...

Granite top table saw.... 447lbs... shipped in a welded steel cage. The 10' from the trailer to the garage never seemed so far.

... it's RIDING season!! See you again when it starts getting cold.

Painted headboard in weird lighting. Waiting for the rain to stop so I can clear out enough room for a trial assembly. The hardware's in...

Top: HF 43430 HVLP stock 1.4 needle. Bottom: PC PSH1 HVLP accessory 2.2 needle. Now that I've brushed out the bed, my new tip and need...

My fancy spray booth is very sensitive to weather conditions. Apparently hooking up a spray gun and charging the compressor pleases the wi...

Headboard's in the clamps - woodworking is done. A lot of stuff happened tonight: Routed a dado on the inside of each leg to accept the ...

That shorter piece on top has been glued up to the wider piece. The curve was marked out (using a template from a previous project), and a ...

Deja vu round three . The screws that hold the hardware to the rails are driven into the endgrain, which doesn't really hold screws well...

Glued up the foot board today. ...and yet more DEJA VU . The looking-worse-for-wear window jig yet again - this time mortising the rails for...

Using floating tenons the same size as the bed hardware allows the router "window" template to be used again. This time the morti...